Removal and Installation
REMOVAL
- Release pawls using a suitable tool and remove the inside mirror cover and rain sensor cover.
- Release pawls using a suitable tool and remove the front camera unit from the front camera unit bracket.
- Disconnect the harness connector from the front camera unit and remove.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Do not touch or shock the front camera unit lens area or drop the front camera unit.
- Make sure that the front camera unit harness is not twisted after installation.
- Align the front camera unit cover clips with the cover bracket holes and install by hand. Do not use excessive force.
- Perform "ADDITIONAL SERVICE WHEN REPLACING FRONT CAMERA UNIT" when removing or replacing the front camera unit. Refer to Description .