Precaution for Blind Spot Warning/Blind Spot Intervention System Service

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Do not use the Blind Spot Intervention system when driving with free rollers or a chassis dynamometer.
Do not perform the active test while driving.
Do not disassemble the front camera unit.
Do not use the front camera unit that is removed from the vehicle.
Do not change BSW initial state ON → OFF without the consent of the customer.

TO KEEP THE BLIND SPOT WARNING/BLIND SPOT INTERVENTION SYSTEM OPERATING PROPERLY, BE SURE TO OBSERVE THE FOLLOWING ITEMS:

Front Camera Unit Maintenance

The front camera unit for the LDW/LDP system is located above the inside mirror. To keep the proper operation of the LDW/LDP systems and prevent a system malfunction, be sure to observe the following:

Always keep the windshield clean.
Do not attach a sticker (including transparent material) or install an accessory near the camera unit.
Do not place reflective materials, such as white paper or a mirror, on the instrument panel. The reflection of sunlight may adversely affect the camera unit capability of detecting the lane markers.
Do not strike or damage the areas around the camera unit.
Do not touch the camera lens or remove the screw located on the camera unit.

System Maintenance

The two side radar for the Blind Spot Warning and Blind Spot Intervention systems are located near the rear bumper.

Always keep the area near the side radar clean.
Do not attach stickers (including transparent material), install accessories or apply additional paint near the side radar.
Do not strike or damage the area around the side radar.