Diagnosis Procedure

Regarding Wiring Diagram information, refer to Wiring Diagram .

1. CHECK CONNECTOR 
   1. Turn the ignition switch OFF.
   2. Check the terminals and connectors of the side radar RH for damage, bend and short (unit side and connector side).

   Is the inspection result normal?

   >>

   GO TO 2.

   >>

   Repair the terminal or connector.

2. CHECK CONTINUITY RIGHT/LEFT SWITCHING SIGNAL CIRCUIT 
   1. Disconnect side radar RH connector.
   2. Check continuity between side radar RH harness connectors and ground.

   Side radar RH		Ground	Continuity
   Connector	Terminal
   M253	3		Yes

   Is the inspection result normal?

   >>

   Inspection End.

   >>

   Repair harness or connector.