Diagnosis Procedure
- CHECK FUSES
Check that the following fuses are not blown:
Signal name Fuse No. Ignition power supply 27 (10A) Is the fuse blown?
>>
Replace the blown fuse after repairing the affected circuit.
>>
GO TO 2.
- CHECK POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect the side radar RH connector.
- Check voltage between side radar RH harness connector and ground.
Terminals Condition Voltage(Approx.) (+) (-) Side radar RH Ground Ignition switch Connector Terminal M253 5 OFF 0 V ON Battery voltage Is the inspection result normal?
>>
GO TO 3.
>>
Repair the side radar RH power supply circuit.
- CHECK GROUND CIRCUIT
Check continuity between side radar RH harness connectors and ground.
Side radar RH Ground Continuity Connector Terminal M253 8 Yes Is the inspection result normal?
>>
Inspection End.
>>
Repair the side radar RH ground circuit.