Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
   • Data link connector
   • 6CH CAN gateway

Is the inspection result normal?

>>

GO TO 2.

>>

Repair the terminal and connector.

1. Disconnect the connector of 6CH CAN gateway.
2. Check the continuity between the 6CH CAN gateway harness connector terminals.

   6CH CAN gateway harness connector			Continuity
   Connector No.	Terminal No.
   M462	8	11	Existed
   	20	23	Existed

Is the inspection result normal?

>>

GO TO 3.

>>

Check the harness and repair the root cause (Diagnostic CAN communication circuit side).

1. Connect the connector of 6CH CAN gateway.
2. Check the resistance between the data link connector terminals.

   Data link connector			Resistance (Ω)
   Connector No.	Terminal No.
   M22	6	14	Approx. 54 - 66

Is the measurement value within the specification?

>>

Check CAN system type decision again.

>>

Error was detected in the data link connector branch line circuit.

>>

Repair the data link connector branch line.