Diagnosis Procedure

Check that the following fuse are not blown.

Is the fuse blown (open)?

>>

Replace the blown fuse after repairing the affected circuit if a fuse is blown.

>>

GO TO 2.

1. Turn the ignition switch OFF.
2. Disconnect the connector of 3CH CAN gateway.
3. Check voltage between 3CH CAN gateway harness connector and ground.

   Terminals			Condition	Voltage(Standard)	Voltage(Reference value)
   (+)		(-)
   3CH CAN gateway		Ground	Ignition switch
   Connector	Terminal
   M454	8		OFF	6 - 16 V	Battery voltage
   	5		ON	7 - 16 V	Battery voltage

Is the measurement value normal?

>>

GO TO 3.

>>

Repair harness or connector.

Check continuity between 3CH CAN gateway harness connector and ground.

Does continuity exist?

>>

INSPECTION END

>>

Repair harness or connector.