DTC Diagnosis Procedure

1. Ignition switch OFF.
2. Disconnect ambient sensor harness connector.
3. Ignition switch ON.
4. Check voltage between ambient sensor harness connector and ground.

   (+)		(-)		Voltage (Approx.)
   Ambient sensor
   Connector	Terminal
   E76	1	Ground		5 V

Is the inspection result normal?

YES

GO TO 2.

NO

GO TO 4.

1. Ignition switch OFF.
2. Check continuity between ambient sensor harness connector and ground.

   Ambient sensor		--		Continuity
   Connector	Terminal
   E76	2	Ground		Yes

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness or connector.

Check ambient sensor. Refer to Component Inspection .

Is the inspection result normal?

YES

Replace combination meter. Refer to Removal and Installation .

NO

Replace ambient sensor. Refer to Removal and Installation .

1. Ignition switch OFF.
2. Disconnect combination meter connector.
3. Check continuity between ambient sensor harness connector and combination meter harness connector.

   Ambient sensor		Combination meter		Continuity
   Connector	Terminal	Connector	Terminal
   E76	1	M77	49	Yes

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace harness or connector.

Check continuity between ambient sensor harness connector and ground.

Is the inspection result normal?

YES

GO TO 6.

NO

Repair or replace harness or connector.

1. Ignition switch ON.
2. Check voltage between ambient sensor harness connector and ground.

   Ambient sensor		--		Voltage (Approx.)
   Connector	Terminal
   E76	1	Ground		0 V

Is the inspection result normal?

YES

Replace combination meter. Refer to Removal and Installation .

NO

Repair or replace harness or connector.