DTC Diagnosis Procedure

1. Ignition switch ON.
2. Check voltage between the following terminals of the trip reset switch harness connector.

   Trip reset switch			Condition	Voltage (Approx.)
   Connector	Terminals
   	(+)	(-)
   M3	2	3	When trip reset switch is pressed	0 V
   			Other than the above	5 V

Is the inspection result normal?

YES

Inspection End.

NO

GO TO 2.

1. Ignition switch OFF.
2. Disconnect combination meter harness connector and trip reset switch harness connector.
3. Check continuity between combination meter harness connector and trip reset switch harness connector.

   Combination meter		Trip reset switch		Continuity
   Connector	Terminal	Connector	Terminal
   M77	43	M3	3	Yes
   	44		2

4. Check continuity between combination meter harness connector and ground.

   Combination meter		--	Continuity
   Connector	Terminal
   M77	43	Ground	No
   	44

Is the inspection result normal?

YES

Inspection End.

NO

Repair or replace harness or connector.