DTC Diagnosis Procedure

1. Ignition switch OFF.
2. Disconnect combination meter harness connector and fuel level sensor unit and fuel pump (fuel level sensor) (main) harness connector.
3. Check continuity between combination meter harness connector and fuel level sensor unit and fuel pump (fuel level sensor) (main) harness connector.

   Combination meter		Fuel level sensor unit and fuel pump (fuel level sensor) (main)		Continuity
   Connector	Terminal	Connector	Terminal
   M77	54	M195	3	Yes

4. Check continuity between combination meter harness connector and ground.

   Combination meter		--	Continuity
   Connector	Terminal
   M77	54	Ground	No

Is the inspection result normal?

YES

GO TO 2.

NO

Repair harness or connector.

Check continuity between fuel level sensor unit and fuel pump (fuel level sensor) (main) harness connector and combination meter harness connector.

Is the inspection result normal?

YES

Replace combination meter. Refer to Removal and Installation .

NO

Repair harness or connector.