DTC Diagnosis Procedure

1. Ignition switch OFF.
2. Disconnect combination meter harness connector and spiral cable harness connector.
3. Check continuity between combination meter harness connector and spiral cable harness connector.

   Combination meter		Spiral cable		Continuity
   Connector	Terminal	Connector	Terminal
   M76	3	M30	2	Yes
   	23		4
   	24		3

4. Check continuity between combination meter harness connector and ground.

   Combination meter		--	Continuity
   Connector	Terminal
   M76	3	Ground	No
   	23
   	24

Is the inspection result normal?

YES

Inspection End.

NO

Repair or replace harness or connector.