Work Procedure

Park the vehicle in a space at least 6.56 feet' (2000 mm) wide by 6.56 feet' (2000 mm) tall by 16.40 feet' (5000 mm) long.

GO TO 2.

• Place markings at the center of the axles.

  Courtesy of NISSAN NORTH AMERICA, INC.

• Place marking tape as shown:

  Courtesy of NISSAN NORTH AMERICA, INC.

• Label the marking tape "a" (right rear axle), "b" (right front axle), "c" (left rear axle) and "d" (left front axle)

GO TO 3.

1. Place a strip of tape on each side of the vehicle 13.12 feet' (4000 mm) long from the center of the rear axles forward, "a" through "b" and "c" through "d".

   Courtesy of NISSAN NORTH AMERICA, INC.

2. Place a mark "e" and "f" on each strip of tape 5.02 feet' (1530 mm) from the center of the front axles. Place a strip of tape from "e" to "f".

   Courtesy of NISSAN NORTH AMERICA, INC.

3. Place a target board on the strip of tape from "e" to "f".

   Courtesy of NISSAN NORTH AMERICA, INC.

GO TO 4.

1. Create a target sheet 8.86 inches (225 mm) wide by 4.13 inches (105 mm) high, with an inner dimension white area of 8.07 inches (205 mm) wide by 3.35 inches (85 mm) high.

   Courtesy of NISSAN NORTH AMERICA, INC.

2. Place the target sheet created in step 1 on the target board 3.50 feet (1070 mm) from the floor. Position the target board so that the center of the target sheet is 1.84 feet (560 mm) from the left side strip of tape.

   Courtesy of NISSAN NORTH AMERICA, INC.

GO TO 5.

• Move the driver seat to the maximum forward position.
• Raise the driver seat to the maximum upper position.
• Move the driver seatback to the maximum forward position.
• Raise the driver seat headrest to the maximum upper position.

GO TO 6.

1. Ignition switch ON.
2. Press the "Menu" button on the Integral switch to launch the "APPS" menu.
3. Select "Settings", then "Head Up Display".

GO TO 7.

CONSULT

1. Select "Distortion calibration" in "Work support" mode of "E-HUD", then select "Start".
2. From the left rear seating position behind the driver seat, view the target sheet looking through the area between the driver seatback and the headrest.

   Courtesy of NISSAN NORTH AMERICA, INC.

3. Follow the CONSULT Work support on screen instructions to align the guide line center with the target sheet center.

   Courtesy of NISSAN NORTH AMERICA, INC.

Work End.