Diagnosis Procedure (With Automatic Back Door)

1. Ignition switch OFF.
2. Disconnect back door lock assembly connector.
3. Check signal between back door lock assembly harness connector and ground using oscilloscope.

   (+)		(-)	Signal (Reference value)
   Back door lock assembly
   Connector	Terminal
   D560	7	Ground	Courtesy of NISSAN NORTH AMERICA, INC. 9.0 - 10.0 V

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Disconnect BCM connector.
2. Check continuity between back door lock assembly harness connector and BCM harness connector.

   Back door lock assembly		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   D560	7	M304	51	Yes

3. Check continuity between back door lock assembly harness connector and ground.

   Back door lock assembly		Ground	Continuity
   Connector	Terminal
   D560	7		No

Is the inspection result normal?

YES

Replace BCM. Refer to Removal and Installation .

NO

Repair or replace harness.

Check continuity between back door lock assembly harness connector and ground.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace harness.

Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 5.

NO

Replace back door lock assembly. Refer to Removal and Installation .

Refer to Intermittent Incident .

Inspection End.