Brake Shoes &/Or Pads: Remove & Replace

Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies To	Note	Standard Hours	Warranty Hours	Skill Level
All		1.8		B
Front,Both Sides		1.0		B
Rear,Both Sides		1.0		B
Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed Brake System.
Each Additional		0.2		B
One		0.3		B
Combination Procedure: BRAKE SYSTEM: Bleed: NOTE: This operation is not to be used with any other operation(s) containing brake fluid bleed.
		0.2		B
Combination Procedure: CALIPER: Overhaul: Includes: Bleed Brake System.
Front,One,Dual Piston Calipers		0.7		B
Rear,One,Single Piston Calipers		0.5		B
Combination Procedure: CALIPER: Replace: Includes: Bleed Brake System.
One		0.3		B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
		0.5		B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,Each	Correct Rotor lateral runout by indexing or correction plate.	0.2		B
Combination Procedure: DISC ROTOR: Remove & Install or Remove & Replace:
Each		0.1		B
Combination Procedure: DISC ROTOR (REMOVED): Refinish: DOES NOT include grind hot spots.
Each Additional		0.3		B
One		0.5		B
Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable:
	Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. Includes: Electronic Parking Brake System Initialization.	0.2		B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,Each	Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.	0.2		B
Combination Procedure: WHEEL BEARING: Replace:
Front,One		0.5		B
Rear,One		0.5		B