Component Inspection
- CHECK TRIP RESET AND ILLUMINATION CONTROL SWITCH
- Turn ignition switch OFF.
- Disconnect trip reset and illumination control switch connector.
- Check trip reset and illumination control switch.
Terminals
Condition
Continuity
Trip reset and illumination control switch
5
6
When trip reset switch is pressed
Existed
Other than the above
Not existed
3
When illumination control switch (+) is pressed
Existed
Other than the above
Not existed
4
When illumination control switch (-) is pressed
Existed
Other than the above
Not existed
Is the inspection result normal?
YES
INSPECTION END
NO
Replace trip reset and illumination control switch. Refer to TRIP RESET AND ILLUMINATION CONTROL SWITCH : Removal & Installation .