Component Function Check

CHECK COMBINATION METER INPUT SIGNAL

Select the "Data Monitor" for the "METER/M&A" and check the "STRG SW INPUT" monitor value.

Condition	Value
BACK switch is pressed	SW1
MENU UP switch is pressed	SW2
MENU DOWN switch is pressed	SW3
VR switch is pressed	SW4
OK switch is pressed	SW5
VOL DOWN switch is pressed	SW6
VOL UP switch is pressed	SW7
TEL switch is pressed	SW8
DISPLAY BACK switch is pressed	SW9
DISPLAY NEXT switch is pressed	SW10
Other than above	NO INPUT

Is the inspection result normal?

YES

INSPECTION END