Diagnosis Procedure

1. Turn ignition switch ON.
2. Check voltage between combination meter harness connector and ground.

   Terminals			Voltage (Approx.)
   (+)		(-)
   Combination meter		Ground
   Connector	Terminal
   M344	50		5 V

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and A/C auto amp. connector.
3. Check continuity between combination meter harness connector and A/C auto amp. harness connector.

   Combination meter		A/C auto amp.		Continuity
   Connector	Terminal	Connector	Terminal
   M344	50	M342	6	Existed

4. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M344	50		Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Repair harness or connector.