Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and washer level switch connector.
3. Check continuity between combination meter harness connector and washer level switch harness connector.

   Terminals				Continuity
   Combination meter		Washer level switch
   Connector	Terminal	Connector	Terminal
   M57	24	E37	1	Existed

4. Check continuity between combination meter harness connector and ground.

   Terminals			Continuity
   Combination meter		Ground
   Connector	Terminal
   M57	24		Not existed

Is the inspection result normal?

YES

GO TO 2.

NO

Repair harness or connector.

Check continuity between washer level switch connector and ground.

Is the inspection result normal?

YES

GO TO 3.

NO

Repair harness or connector.

Check washer level switch. Refer to Component Inspection .

Is the inspection result normal?

YES

Replace combination meter. Refer to COMBINATION METER : Removal & Installation .

NO

Replace washer level switch. Refer to FRONT WASHER LEVEL SWITCH : .