With ICC

1. Disconnect combination meter harness connector and spiral cable harness connector.
2. Check continuity between combination meter harness connector and spiral cable harness connector.

   Combination meter		Spiral cable		Continuity
   Connector	Terminal	Connector	Terminal
   M57	23	M190	33	Existed

3. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M57	23		Not existed

Is the inspection result normal?

YES

GO TO 2.

NO

Repair harness or connector.

1. Check continuity between combination meter harness connector and spiral cable harness connector.

   Combination meter		Spiral cable		Continuity
   Connector	Terminal	Connector	Terminal
   M57	21	M190	32	Existed

2. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M57	21		Not existed

Is the inspection result normal?

YES

GO TO 3.

NO

Repair harness or connector.

1. Disconnect steering switch connector.
2. Check continuity between spiral cable harness connectors.

   Spiral cable				Continuity
   Terminal
   33		14		Existed
   32		15

Is the inspection result normal?

YES

GO TO 4.

NO

Replace spiral cable. Refer to SPIRAL CABLE : Removal & Installation .

Check steering switch. Refer to Component Inspection .

Is the inspection result normal?

YES

INSPECTION END

NO

Replace steering switch. Refer to STEERING SWITCH : Removal & Installation .