Component Inspection

1. Turn ignition switch OFF.
2. Disconnect meter control switch connector.
3. Check continuity between the following terminals of the meter control switch.

   Terminals		Condition	Continuity
   Meter control switch
   6	4	When illumination control switch (+) is pressed	Existed
   		Other than the above	Not existed
   7		When illumination control switch (-) is pressed	Existed
   		Other than the above	Not existed
   5		When trip reset switch is pressed	Existed
   		Other than the above	Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace meter control switch. Refer to METER CONTROL SWITCH : Removal & Installation .