LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2021 >> Q50 Signature Edition, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Transfer Case (Service Information)) >> Removal And Installation >> Transfer Assembly >> TRANSFER ASSEMBLY : Unit Removal & Installation >> Removal

TRANSFER ASSEMBLY : Unit Removal & Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove rear propeller shaft. Refer to REAR PROPELLER SHAFT : Removal & Installation .
  2. Remove front propeller shaft. Refer to FRONT PROPELLER SHAFT : Removal & Installation .
  3. Disconnect AWD solenoid harness connector and separate harness from transfer assembly.
  4. Remove control rod of A/T. Refer to CONTROL ROD : Removal & Installation .
  5. Support transfer assembly and transmission assembly with a jack.
    CAUTION: Secure transfer assembly and transmission assembly to a jack.
  6. Remove rear engine mounting member and rear engine mount/engine mounting insulator (rear). Refer to ENGINE ASSEMBLY : Exploded View .
  7. Lower jack to the position where the top transfer mounting bolts can be removed.
    G04144529Courtesy of NISSAN NORTH AMERICA, INC.
  8. Remove transfer breather hose. Refer to TRANSFER AIR BREATHER : Removal & Installation .
  9. Remove transfer mounting bolts and separate transfer from transmission.
scientia non olet · About LEMON Manuals