REAR FINAL DRIVE SIDE OIL SEAL : Removal & Installation: Installation
WARNING: This page is about a different variant/trim than selected.
- Apply multi-purpose grease to side oil seal lips.
- Install side oil seal until it becomes flush with the case end, using the drift (A) [SST: KV40104830 (--)].CAUTION:
- Never reuse oil seal.
- When installing, never incline oil seal.
- Install final drive assembly. Refer to REAR FINAL DRIVE ASSEMBLY : Unit Removal & Installation .
- Perform inspection after installation. Refer to REAR FINAL DRIVE SIDE OIL SEAL : Inspection .