TRANSFER FRONT DRIVE SHAFT AND DRIVE CHAIN : Disassembly & Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.

Separate front case and rear case. Refer to TRANSFER FRONT CASE AND REAR CASE : Disassembly & Assembly .
Remove drive chain and front drive shaft assembly.
CAUTION: Never use tools. Always remove by hand.

Remove front drive shaft front bearing with the drift (A) and separator (B).

Courtesy of NISSAN NORTH AMERICA, INC.

A	: Drift [SST: ST31214000 (J-25269-B)]
B	: Separator (commercial service tool)

Remove front drive shaft rear bearing with the drift (A) and separator (B).

Courtesy of NISSAN NORTH AMERICA, INC.

A	: Drift [SST: ST31214000 (J-25269-B)]
B	: Separator (commercial service tool)

Remove plug from front drive shaft.
Perform inspection after disassembly. Refer to TRANSFER FRONT DRIVE SHAFT AND DRIVE CHAIN : Inspection .