LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2021 >> Q50 Signature Edition, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Transfer Case (Service Information)) >> Disassembly And Assembly >> Transfer >> Transfer Front Drive Shaft And Drive Chain >> TRANSFER FRONT DRIVE SHAFT AND DRIVE CHAIN : Disassembly & Assembly >> Assembly

TRANSFER FRONT DRIVE SHAFT AND DRIVE CHAIN : Disassembly & Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install plug to front drive shaft.
    CAUTION: Never reuse plug.
  2. Install front drive shaft front bearing with the drift (A) [SST: ST33200000 (J-26082)].
    GNSJPDIE0138Z-138Courtesy of NISSAN NORTH AMERICA, INC.
  3. Install front drive shaft rear bearing with the drift (A) [SST: KV38104010 (--)].
    GNSJPDIE0139Z-139Courtesy of NISSAN NORTH AMERICA, INC.
  4. Set drive chain to front drive shaft.
    CAUTION: Identification mark SYMBOL of drive chain should be in the side of front bearing SYMBOL of front drive shaft.
    GNSJPDIE0075Z-075Courtesy of NISSAN NORTH AMERICA, INC.
  5. Install drive chain to main shaft, and then install front drive shaft.
    CAUTION: Never use tools. Always install by hand.
  6. Install front case to rear case. Refer to TRANSFER FRONT CASE AND REAR CASE : Disassembly & Assembly .
scientia non olet · About LEMON Manuals