Diagnosis Procedure

1. Turn ignition switch OFF.
2. Check 7.5A fuse (No. 34, located in fuse and fusible link block 2).

Is the inspection result normal?

YES

GO TO 2.

NO

Replace the blown fuse after repairing the affected circuit if a fuse is blown.

1. Turn ignition switch ON.
2. Check voltage between A/C auto amp. harness connector and ground.

   +		-	Voltage (Approx.)
   A/C auto amp.
   Connector	Terminal
   M36	16	Ground	Battery voltage

Is the inspection result normal?

YES

GO TO 3.

NO

Repair A/C auto amp. battery power supply circuit

1. Turn ignition switch OFF.
2. Disconnect A/C auto amp. connector.
3. Check continuity between A/C auto amp. harness connector and ground.

   A/C auto amp.		--	Continuity
   Connector	Terminal
   M36	15	Ground	Existed

Is the inspection result normal?

YES

A/C auto amp. power supply and ground circuit are normal.

NO

Repair harness or connector.