Component Inspection (Heated Steering Wheel)

1. Turn ignition switch OFF.
2. Remove the heated steering wheel. Refer to Removal and Installation .
3. Check continuity between heated steering wheel harness connector terminal and ground.

   Heated steering wheel	Condition	Continuity
   Terminal
   1 - 2	Leather surface temperature of 20 deg.C (68 deg.F) or less	Existed
   	Leather surface temperature of 30 deg.C (86 deg.F) or more	Not existed

Is the inspection result normal?

YES

GO TO 2.

NO

Replace heated steering wheel. Refer to Removal and Installation .

Check resistance between heated steering wheel connector terminals.

Is the inspection result normal?

YES

INSPECTION END

NO

Replace heated steering wheel. Refer to Removal and Installation .