Diagnosis Procedure
- CHECK FUSE
Check for blown fuses.
Power source
Fuse No.
Battery
88
Is the inspection result normal?
YES
GO TO 2.
NO
Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between combination meter harness connector and ground.
Probe
Ignition switch position
Voltage
(Approx.)
+
-
Combination meter
Connector
Terminal
M32
4
Ground
OFF
Battery voltage
Is the inspection result normal?
YES
GO TO 3.
NO
Check harness between combination meter and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter connector.
- Check continuity between combination meter harness connector and ground.
Combination meter
Ground
Continuity
Connector
Terminal
M32
1
Existed
Is the inspection result normal?
YES
Check intermittent incident. Refer to Intermittent Incident .
NO
Repair harness or connector.