Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Check the voltage between electric parking brake control module harness connector and ground.

   +		-	Voltage
   Electric parking brake control module
   Connector	Terminal
   M70	13	Ground	11 - 15.5 V
   	15
   	22

Is the inspection result normal?

YES

GO TO 3.

NO

GO TO 2.

1. Turn the ignition switch OFF.
2. Check the 30A fuse (#74), 30A fuse (#73) and 5A fuse (#93).
3. Disconnect the electric parking brake control module harness connector.
4. Disconnect the fuse and fusible link block 2 harness connector.
5. Check for continuity between electric parking brake control module harness connector and the fuse and fusible link block 2 harness connector.

   Electric parking brake control module		Fuse and fusible link block 2		Continuity
   Connector	terminal	Connector	Terminal
   M70	13	M108	14	Existed
   	15		13
   	22	M128	78

Is the inspection result normal?

YES

Perform trouble diagnosis for battery power supply.

NO

Repair/replace harness, connector or fuse.

1. Turn the ignition switch OFF.
2. Disconnect the electric parking brake control module harness connector.
3. Check for continuity between electric parking brake control module harness connector and the ground.

   Electric parking brake control module		--	Continuity
   Connector	Terminal
   M70	28	Ground	Existed
   	30

Is the inspection result normal?

YES

GO TO 4.

NO

Repair/replace harness or connector.

Check electric parking brake control module pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES

INSPECTION END

NO

Repair/replace harness or connector.