Work Procedure

1. Park the vehicle in the straight-forward position.
2. Unload the vehicle (no passenger aboard).

GO TO 2.

With CONSULT

1. Turn ignition switch ON.
2. Select "Work Support" mode of "H/L control module LH" using CONSULT.
3. Select and start the "Zero position adjustment".

Is the sensor initialize completed?

YES

GO TO 3.

NO

Perform the sensor initialize again.

With CONSULT

1. Select "Self Diagnostic Result" mode of "H/L control module LH" using CONSULT.
2. Check DTC.

Is DTC detected?

YES

GO TO 2.

NO

WORK END