Diagnosis Procedure
- CHECK SELF DIAGNOSTIC RESULT
Check DTC using CONSULT.
What is the display history of DTC?
"PAST"
GO TO 2.
"CRNT"
GO TO 3.
- ERASE DTC
- Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
- Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE".
Is DTC detected?
YES
GO TO 3.
NO
Check intermittent incident. Refer to Intermittent Incident .
- CHECK SWITCH OPERATION
Check the operation of each switch on upper control panel control unit is normal.
Is the inspection result normal?
YES
Replace BCM. Refer to Removal and Installation .
NO
Replace upper control panel control unit. Refer to Removal and Installation .