Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect BCM and front fog lamp RH connector.
3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   E16	143		Not existed

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

1. Check continuity between BCM harness connector and front fog lamp RH harness connector.

   BCM		Front fog lamp RH		Continuity
   Connector	Terminal	Connector	Terminal
   E16	143	E68	2	Existed

2. Check voltage between BCM harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   BCM
   Connector	Terminal
   E16	143	Ground	0 V

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

1. Connect BCM and front fog lamp RH connector.
2. Turn ignition switch ON.
3. Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
4. Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .

Is DTC detected?

YES

GO TO 4.

NO

INSPECTION END

1. Turn ignition switch OFF.
2. Replace front fog lamp RH. Refer to Removal and Installation .
3. Turn ignition switch ON.
4. Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
5. Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .

Is DTC detected?

YES

Replace BCM. Refer to Removal and Installation .

NO

INSPECTION END