Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect BCM and front fog lamp LH connector.
3. Check continuity between BCM harness connector and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   E15	131		Not existed

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

1. Check continuity between BCM harness connector and front fog lamp LH harness connector.

   BCM		Front fog lamp LH		Continuity
   Connector	Terminal	Connector	Terminal
   E15	131	E67	2	Existed

2. Check voltage between BCM harness connector and ground.

   (+)		(-)	Voltage (Approx.)
   BCM
   Connector	Terminal
   E15	131	Ground	0 V

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

1. Connect BCM and front fog lamp LH connector.
2. Turn ignition switch ON.
3. Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
4. Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .

Is DTC detected?

YES

GO TO 4.

NO

INSPECTION END

1. Turn ignition switch OFF.
2. Replace front fog lamp LH. Refer to Removal and Installation .
3. Turn ignition switch ON.
4. Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
5. Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .

Is DTC detected?

YES

Replace BCM. Refer to Removal and Installation .

NO

INSPECTION END