Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect following connectors.
   • Rear combination lamp RH (body side)
   • Rear combination lamp RH (back door side)
3. Check continuity between rear combination lamp RH (body side) harness connector and ground.

   Rear combination lamp RH (body side)		Ground	Continuity
   Connector	Terminal
   M195	6		Not existed

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace harness.

1. Connect following connectors.
   • Rear combination lamp RH (body side)
   • Rear combination lamp RH (back door side)
2. Turn ignition switch ON.
3. Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
4. Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .

Is DTC detected?

YES

GO TO 3.

NO

INSPECTION END

1. Turn ignition switch OFF.
2. Replace corresponding rear combination lamp RH. Refer to Removal and Installation (body side) or Removal and Installation (back door side)
3. Turn ignition switch ON.
4. Select "Self Diagnostic Result" mode of "BCM" using CONSULT.
5. Erase DTC, and then repeat "DTC CONFIRMATION PROCEDURE". Refer to DTC Description .

Is DTC detected?

YES

Replace BCM. Refer to Removal and Installation .

NO

INSPECTION END