C0049-15, C0049-7B

Check power supply and ground circuit of BCM. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace the malfunctioning parts.

1. Turn the ignition switch OFF.
2. Check the brake fluid level. Refer to Inspection .

Is the inspection result normal?

YES

GO TO 4.

NO

Refill the brake fluid, and GO TO 3.

• Refer to Refilling .

Perform DTC confirmation procedure again. Refer to DTC Description .

Is DTC C0049 detected again?

YES

GO TO 4.

NO

INSPECTION END

1. Turn the ignition switch off.
2. Disconnect the brake fluid level switch harness connector.
3. Connect decade resistor to the brake fluid level switch connector.
4. Check resistance brake fluid level switch.

   Check result	Specified value
   10 kOhm	OK
   1 Ohm	Not OK

Is the inspection result normal?

YES

GO TO 5.

NO

Replace brake master cylinder. Refer to Removal and Installation .

1. Disconnect the BCM harness connector.
2. Check the continuity between brake fluid level switch harness connector and BCM harness connector.

   Brake fluid level switch		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   E10	1	E16	164	Existed
   	2	E15	138	Existed

3. Check the continuity between brake fluid level switch harness connector and ground.

   Brake fluid level switch		--	Continuity
   Connector	Terminal
   E10	2	Ground	Not existed

Is the inspection result normal?

YES

Replace brake master cylinder. Refer to Removal and Installation .

NO

Repair harness or connector.