Diagnosis Procedure
- CHECK HARNESS CONNECTOR CONNECTION
Check the following harness connector for disconnection or looseness.
- CAN potential distributor electrical connector (body)
- Electronic ignition switch control unit
Is the inspection result normal?
YES
GO TO 2.
NO
Securely connect the harness connectors.
- CHECK POWER SUPPLY AND GROUND CIRCUIT
Check power supply and ground circuit for electronic ignition switch control unit. Refer to Wiring Diagram .
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace the malfunctioning part.
- CHECK CIRCUIT (SHORT TO BATTERY)
- Turn ignition switch OFF.
- Disconnect the following unit connectors.
- CAN potential distributor electrical connector (body)
- Electronic ignition switch control unit
- Check voltage between CAN potential distributor electrical connector (body) harness connector and ground.
Terminals
Voltage
(Approx.)
+
-
CAN potential distributor electrical connector (body)
Ground
Connector
Terminal
M324
20
--
0 V
21
Is the inspection result normal?
YES
GO TO 4.
NO
Repair or replace harness.
- CHECK CIRCUIT (SHORT TO GROUND)
Check continuity between CAN potential distributor electrical connector (body) harness connector and ground.
CAN potential distributor electrical connector (body)
Ground
Continuity
Connector
Terminal
M324
20
--
Not existed
21
Is the inspection result normal?
YES
GO TO 5.
NO
Repair or replace harness.
- CHECK CIRCUIT (SHORT WITH CAN-H AND CAN-L)
Check continuity between CAN potential distributor electrical connector (body) harness connector terminals.
CAN potential distributor electrical connector (body)
Continuity
Connector
Terminal
Connector
Terminal
M324
20
M324
21
Not existed
Is the inspection result normal?
YES
GO TO 6.
NO
Repair or replace harness.
- CHECK CIRCUIT (OPEN)
Check continuity between the following unit harness connectors.
- CAN potential distributor electrical connector (body)
- Electronic ignition switch control unitCAN potential distributor electrical connector (body) - Electronic ignition switch control unit
CAN potential distributor electrical connector (body)
Electronic ignition switch control unit
Continuity
Connector
Terminal
Connector
Terminal
M324
20
M327
3
Existed
21
4
Is the inspection result normal?
YES
INSPECTION END
NO
Repair or replace harness.