Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
   • Around view monitor control unit
   • CAN gateway

Is the inspection result normal?

YES

GO TO 2.

NO

Repair the terminal and connector.

1. Disconnect the connector of CAN gateway.
2. Check the continuity between the CAN gateway harness connector terminals.

   CAN gateway harness connector				Continuity
   Connector No.	Terminal No.	Connector No.	Terminal No.
   M218	20	M217	9	Existed
   	19		3	Existed

Is the inspection result normal?

YES

GO TO 3.

NO

Check the harness and repair the root cause (Multifunction media CAN communication circuit).

1. Connect the connector of CAN gateway.
2. Disconnect the connector of around view monitor control unit.
3. Check the resistance between the around view monitor control unit harness connector terminals.

   Around view monitor control unit harness connector			Resistance (Ohm)
   Connector No.	Terminal No.
   M8	26	24	Approx. 54 - 66

Is the measurement value within the specification?

YES

GO TO 4.

NO

Repair the around view monitor control unit branch line.

Check the power supply and the ground circuit of the around view monitor control unit. Refer to Diagnosis Procedure .

Is the inspection result normal?

YES

Replace the around view monitor control unit. Refer to Removal and Installation .

YES

Error was detected in the around view monitor control unit branch line.

NO

Repair the power supply and the ground circuit.