DTC B210D-16

Check battery voltage.

Is the inspection result normal?

YES

GO TO 2.

NO

Repair or replace the malfunctioning parts.

Check that the following fuse are not blown.

Is the fuse blown (open)?

YES

Replace the blown fuse after repairing the affected circuit if a fuse is blown.

NO

GO TO 3.

1. Turn ignition switch OFF.
2. Disconnect combination meter connector.
3. Turn ignition switch ON.
4. Check the voltage between combination meter harness connector and ground.

   Probe			Standard	Voltage (Approx.)
   (+)		(-)
   Combination meter
   Connector	Terminal
   M32	4	Ground	11.0 V - 15.5 V	Battery voltage

Is the inspection result normal?

YES

Check electrical lines and connectors for loose contact and corrosion.

NO

GO TO 4.

Check battery. Refer to Work Procedure .

Is the inspection result normal?

YES

GO TO 5.

NO

Repair or replace the malfunctioning parts.

Check charging system condition. Refer to Work Flow (With EXP-800 NI or GR8-1200 NI) (With EXP-800 NI or GR8-1200 NI) or Work Flow (Without EXP-800 NI or GR8-1200 NI) (Without EXP-800 NI or GR8-1200 NI).

Is the inspection result normal?

YES

Replace combination meter. Refer to Removal and Installation .

NO

Repair or replace the malfunctioning parts.