DTC Detection Logic
|
DTC |
CONSULT screen terms |
DTC detection condition |
|||
|
(Trouble diagnosis content) |
[Malfunction type] |
||||
|
B210A |
84 |
Power Supply circuit (The power supply in the system is too low) |
SIG BELOW ALLOWABLE RANGE |
Diagnosis condition |
Ignition switch is ON |
|
Signal (terminal) |
Battery voltage signal (CAN message from electronic ignition switch control unit) |
||||
|
Threshold |
Battery voltage signal < 10 V +/- 0.2 V |
||||
|
Diagnosis delay time |
60 seconds or more |
||||
NOTE:
The DTC is set if the value for the battery power supply voltage received via the CAN bus is below the permissible voltage range.