Work Procedure
- TIRE PRESSURE SENSOR ID REGISTRATION PROCEDURE CAUTION: To perform ID registration, observe the following points:
- Never register ID in a place where radio waves are interfered (e.g. radio tower).
- Never register ID in a place close to vehicles including TPMS.
With CONSULT.
- Turn the ignition switch ON.
- Display the "WORK SUPPORT" screen and select "ID REGIST".
- Select the start button on the "ID REGIST" screen.
- Contact the Tire Pressure Sensor activation tool (J-50190 or J-45295-A) (1) to the side of the tire at the location to the Tire Pressure Sensor.
- Press and hold the Tire Pressure Sensor Tire Pressure Sensor activation tool button while pushing the tool to the tire surface. (approximately for 5 seconds)CAUTION: Perform the ID registration procedure starting from the vehicle front left wheel, then repeat the procedure in the order of the front right wheel, rear right wheel, and rear left wheel.
- When ID registration is completed, check the following pattern at each wheel.
Sequence
ID registration position
Turn signal lamp
CONSULT
1
Front left wheel
2 blinks
"Red"
↓
"Green"
2
Front right wheel
3
Rear right wheel
4
Rear left wheel
- After the ID registration procedure for all wheels is completed, press "End" to end ID registration, and check that ID registration for all wheels is completed.
Is the check result normal?
YES
ID registration END.
NO
Refer to Diagnosis Procedure .