LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> Suspension >> Rear Suspension (Except Hybrid) >> Removal And Installation >> Suspension Arm >> Removal and Installation >> Removal

Removal and Installation: Removal

Right Side 

  1. Remove rear suspension assembly. Refer to Removal and Installation .
  2. Remove stabilizer connecting rod from suspension arm. Refer to Removal and Installation .
  3. Separate suspension arm from axle housing. Refer to Removal and Installation .
  4. Remove suspension arm from axle housing.
  5. Remove stopper bushing, bolts, and nuts, and then remove suspension arm from suspension member.
  6. Perform inspection after removal. Refer to Inspection .

Left Side 

NOTE: When removing and installing the right side at the same time, it is efficient to remove the suspension arm assembly.
  1. Remove tire with power tool. Refer to Exploded View .
  2. Remove caliper assembly. Hang caliper assembly in a place where it will not interfere with work. Refer to Removal and Installation (1 piston type), Removal and Installation (2 piston type).
    CAUTION: Never depress brake pedal while brake caliper is removed.
  3. Remove disc rotor. Refer to Removal and Installation .
  4. Remove drive shaft. Refer to Removal and Installation .
  5. Remove shock absorber from axle housing. Refer to Removal and Installation .
  6. Remove height sensor from suspension arm. (With AFS) Refer to Removal and Installation .
  7. Remove stabilizer connecting rod from suspension arm. Refer to Removal and Installation .
  8. Separate suspension arm from axle housing. Refer to Removal and Installation .
  9. Remove stopper bushing, bolt, and nut, and then remove suspension arm from suspension member.
  10. Perform inspection after removal. Refer to Inspection .
scientia non olet · About LEMON Manuals