LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRS Airbag (Except Hybrid) >> Removal And Installation >> Driver Air Bag Module >> Removal and Installation >> Removal

Removal and Installation: Removal

  1. Remove the side lid (LH/RH).
  2. Remove the TORX bolts (LH/RH) from the steering wheel lower side.
  3. Pull out the driver air bag module.
  4. Disconnect the driver air bag harness connectors.
    G04145012Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • For installing/removing the driver air bag module harness connector, insert thin screwdriver wrapped in tape into notch, lift lock and remove the connector.
    • Install the connector with lock raised, and push lock into the connector.
    • After installing the connector, check that the lock is pushed securely into it.
  5. Remove the driver air bag module.
CAUTION:
  • Always place the driver air bag module with pad side facing upward.
    GNSJMHIA0539Z-539Courtesy of NISSAN NORTH AMERICA, INC.

    SYMBOL

    : Upward
  • Never impact the driver air bag module.
    GNSJMHIA09Z-009Courtesy of NISSAN NORTH AMERICA, INC.
  • Replace the driver air bag module if it has been dropped or sustained an impact.
  • Never insert any foreign objects (screwdriver, etc.) into the driver air bag module.
  • Never disassemble the driver air bag module.
  • Never expose the driver air bag module to temperatures exceeding 90 deg. C (194 deg. F).
  • Never allow oil, grease, detergent, or water to come in contact with the driver air bag module.
scientia non olet · About LEMON Manuals