LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Transfer Case (Except Hybrid)) >> Unit Removal And Installation >> Transfer Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove rear propeller shaft. Refer to Removal and Installation .
  2. Remove front propeller shaft. Refer to Removal and Installation .
  3. Disconnect AWD solenoid harness connector and separate harness from transfer assembly.
  4. Remove transfer breather hose.
  5. Remove control rod. Refer to Removal and Installation .
  6. Support transfer assembly and transmission assembly with a jack.
    CAUTION: Secure transfer assembly and transmission assembly to a jack.
  7. Remove rear engine mounting member and engine mounting insulator with power tool. Refer to Removal and Installation .
  8. Lower jack to the position where the top transfer mounting bolts can be removed.
  9. Remove transfer mounting bolts with power tool and separate transfer from transmission.
scientia non olet · About LEMON Manuals