Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

• When installing the transfer to the transmission, install the mounting bolts following the standard below, tighten bolts to the specified torque.

  Courtesy of NISSAN NORTH AMERICA, INC.

  Bolt No.	A	B	C	D
  Quantity	4	3	4	2
  Bolt length " L " mm (in)	75 (2.95)	45 (1.77)	40 (1.57)	30 (1.18)

  : Transfer to transmission.

  : Transmission to transfer.

• When installing transfer air breather hose, make sure there are no pinched or restricted areas on the transfer air breather hose caused by bending or winding.
  • Be sure to insert until front side end (A) of air breather hose (1) reaches the end and rear side end (B) reaches the tube bent R.

    Courtesy of NISSAN NORTH AMERICA, INC.

    : Vehicle front

• After the installation, check the fluid level, fluid leakage and the A/T positions. Refer to Inspection .