Transfer Fluid: Refilling
WARNING: This page is about a different variant/trim than selected.
- Remove filler plug (1) and gasket. Then fill fluid up to mounting hole for the filler plug.
Recommended fluid and capacity
: Refer to Fluids and Lubricants .
CAUTION: Carefully fill the fluid. (Fill up for approximately 3 minutes.) - Leave the vehicle for 3 minutes, and check the fluid level again.
- Set a new gasket onto filler plug, and install it on transfer and tighten to the specified torque. Refer to Exploded View .CAUTION: Never reuse gasket.