Physical Values

WARNING: This page is about a different variant/trim than selected.

Terminal No. (Wire color)		Description		Condition	Value (Approx.)
+	-	Signal name	Input/Output
1 (BR)	Ground	AWD solenoid power supply	Output	Engine speed: At idle	0 V
				Engine speed: 3, 000 RPM or more constant	3.1 V*
2 (R)	Ground	AWD solenoid ground	Input	Engine speed: At idle	0 V
				Engine speed: 3, 000 RPM or more constant	0 V
3 (W)	Ground	Transfer fluid temperature sensor ground	Input	Always	0 V
7 (Y)	Ground	Ignition switch	Input	Ignition switch: ON	Battery voltage
				Ignition switch: OFF	0 V
8 (L)	--	CAN-H	Input/Output	--	--
9 (SB)	Ground	Power supply (AWD solenoid)	Input	Always	Battery voltage
10 (B/Y)	Ground	Ground	--	Always	0 V
11 (B/Y)	Ground	Ground	--	Always	0 V
13 (LG)	Ground	Transfer fluid temperature sensor power supply	Output	Transfer temperature: 20 deg. C (68 deg. F)	1.56 V
				Transfer temperature: 80 deg. C (176 deg. F)	0.44 V
15 (G)	Ground	Power supply (AWD control unit)	Input	Always	Battery voltage
16 (P)	--	CAN-L	Input/Output	--	--

*: The values are changed by throttle opening and engine speed.

CAUTION: When using circuit tester to measure voltage for inspection, be sure not to extend forcibly any connector terminals.