Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK TRANSFER FLUID TEMPERATURE SENSOR SIGNAL (1)

Turn the ignition switch OFF.
Disconnect AWD solenoid harness connector.
Turn the ignition switch ON.

Check the voltage between AWD solenoid harness connector terminals.

AWD solenoid

Voltage

(Approx.)

Connector

Terminal

F57

2.5 V

Is the inspection result normal?

YES

GO TO 2.

GO TO 3.

CHECK TRANSFER FLUID TEMPERATURE SENSOR
Check Transfer Fluid Temperature Sensor. Refer to Component Inspection .

Is the inspection result normal?

YES

GO TO 6.

NO

AWD solenoid is malfunctioning. Replace Electric Controlled Coupling. Refer to Exploded View .

CHECK TRANSFER FLUID TEMPERATURE SENSOR SIGNAL (2)

Check the voltage between AWD solenoid harness connector and ground.

AWD solenoid

Voltage

(Approx.)

Connector

Terminal

F57

Ground

2.5 V

Is the inspection result normal?

YES

GO TO 4.

GO TO 5.

CHECK AWD CONTROL UNIT GROUND

Turn the ignition switch OFF.
Disconnect AWD Control Unit harness connector.

Check the continuity between AWD Control Unit harness connector and ground.

AWD Control Unit		--	Continuity
Connector	Terminal
B17	10	Ground	Existed
	11

Is the inspection result normal?

YES

GO TO 5.

Repair or replace error-detected parts.

CHECK TRANSFER FLUID TEMPERATURE SENSOR CIRCUIT

Turn the ignition switch OFF.
Disconnect AWD Control Unit harness connector.

Check the continuity between AWD Control Unit harness connector and AWD solenoid harness connector.

AWD Control Unit		AWD solenoid		Continuity
Connector	Terminal	Connector	Terminal
B17	13	F57	6	Existed
	3		7

Check the continuity between AWD Control Unit harness connector and the ground.

AWD Control Unit		--	Continuity
Connector	Terminal
B17	13	Ground	Not existed
	3

Is the inspection result normal?

YES

GO TO 2.

Repair or replace error-detected parts.

CHECK TERMINALS AND HARNESS CONNECTORS
- Check AWD Control Unit pin terminals for damage or loose connection with harness connector.
- Check Transfer Fluid Temperature Sensor pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?

YES

Replace AWD Control Unit. Refer to Removal and Installation .

NO

Repair or replace error-detected parts.