Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK AWD SOLENOID CIRCUIT (1)
- Turn the ignition switch OFF.
- Disconnect AWD Control Unit harness connector.
- Check the continuity between AWD Control Unit harness connector and the ground.
AWD Control Unit
--
Continuity
Connector
Terminal
B17
1
Ground
Not existed
2
Is the inspection result normal?
YES
GO TO 4.
NO
GO TO 2.
- CHECK AWD SOLENOID
- Disconnect AWD solenoid harness connector.
- Check the continuity between AWD solenoid harness connector and the ground.
AWD solenoid
--
Continuity
Terminal
1
Ground
Not existed
2
Is the inspection result normal?
YES
GO TO 3.
NO
Replace Electric Controlled Coupling. Refer to Exploded View .
- CHECK AWD SOLENOID CIRCUIT
Check the continuity between AWD Control Unit harness connector and the ground.
AWD Control Unit
--
Continuity
Connector
Terminal
B17
1
Ground
Not existed
2
Is the inspection result normal?
YES
GO TO 4.
NO
Repair or replace damaged parts.
- CHECK TERMINALS AND HARNESS CONNECTORS
- Check AWD Control Unit pin terminals for damage or loose connection with harness connector.
- Check AWD solenoid pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES
After connecting each harness connector, perform DTC confirmation procedure again. When DTC "C1205" is detected, replace AWD Control Unit. Refer to Removal and Installation .
NO
Repair or replace damaged parts.