LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2018 >> Q70 5.6 Luxe, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Front Suspension (AWD) (Except Hybrid)) >> AWD >> Removal And Installation >> Front Coil Spring And Shock Absorber >> Disposal

Front Coil Spring And Shock Absorber: Disposal

WARNING: This page is about a different variant/trim than selected.
  1. Set shock absorber horizontally with the piston rod fully extended.
  2. Drill 2 - 3 mm (0.08 - 0.12 in) hole at the position (SYMBOL ) from top as shown in the figure below, to release gas gradually.
    GNSNNEIA0021Z-021Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:
    • Wear eye protection (safety glasses).
    • Wear gloves.
    • Be careful with metal chips or oil blown out by the compressed gas.
    NOTE:
    • Drill vertically in this direction (SYMBOL ).
    • Directly to the outer tube avoiding brackets.
    • The gas is clear, colorless, odorless, and harmless.

    A

    : 20 - 30 mm (0.79 - 1.18 in)
  3. Position the drilled hole downward and drain oil by moving the piston rod several times.
    CAUTION: Dispose of drained oil according to the law and local regulations.
scientia non olet · About LEMON Manuals