Right Side: Installation

WARNING: This page is about a different variant/trim than selected.

Note the following, and install in the reverse order of removal.

Final Drive Side

Replace front final drive side oil seal. Refer to Removal and Installation .
Place the protector (A) [SST: KV38107900 (-)] onto final drive to prevent damage to the oil seal while inserting drive shaft. Slide drive shaft sliding joint and tap with a hammer to install securely.

Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Check that circular clip is completely engaged.

Wheel Side

Clean the matching surface of wheel hub lock nut and wheel hub and bearing assembly.
CAUTION: Never apply lubricating oil to these matching surface.
Since the drive shaft is assembled by press-fitting, use the tightening torque range for the wheel hub lock nut.
CAUTION: Be sure to use torque wrench to tighten the wheel hub lock nut. Never use a power tool.
Perform the final tightening of each of parts under unladen conditions, which were removed when removing wheel hub and bearing assembly and steering knuckle.