Left Side: Installation

WARNING: This page is about a different variant/trim than selected.

Note the following, and install in the reverse order of the removal.

Clean the matching surface of wheel hub lock nut and wheel hub and bearing assembly.
CAUTION: Never apply lubricating oil to these matching surface.
Since the drive shaft is assembled by press-fitting, use the tightening torque range for the wheel hub lock nut.
CAUTION: Be sure to use torque wrench to tighten the wheel hub lock nut. Never use a power tool.
Perform the final tightening of each of parts under unladen conditions, which were removed when removing wheel hub and bearing assembly and steering knuckle.