Main Bearing Cap Sub Bolt Outer Diameter
- Measure the outer diameters (A), (B) at two positions as shown in the figure, below.
c
: 20 mm (0.79 in)
d
: 50 mm (1.97 in)
e
: 9 mm (0.35 in)
- If reduction appears in (A) range, regard it (B).
Limit [(B) - (A)]
: 0.13 mm (0.0051 in)
- If it exceeds the limit (large difference in dimensions), replace main bearing cap sub bolts with new one.